Salt Spray Test Standard for Connectors

Classification:

Release time:

2026-07-10 15:46

Connector salt spray testing is primarily used to evaluate the corrosion resistance of connectors under simulated high-salt, high-humidity conditions, thereby verifying the protective performance of their plating, predicting their service life, and assessing their environmental adaptability. Test standards are broadly categorized into international standards, national standards, industry standards, and enterprise/customer‑specific standards, as follows:

1. International Standard IEC 60068‑2‑11: “Environmental Testing — Part 2: Tests — Test Ka: Salt Spray,” widely used for electronic components, specifies continuous salt‑spray test conditions (e.g., 5% NaCl, 35°C). IEC 60068‑2‑52: “Environmental Testing — Part 2: Tests — Test Kb: Salt Spray, Cyclic,” defines alternating (cyclic) salt‑spray test conditions (e.g., spray–dry–damp‑heat cycling), which more closely simulate real‑world environments and are commonly applied to outdoor connector testing. IEC 60512‑11‑6: “Connectors for Electronic Equipment — Tests and Measurements — Part 11‑6: Climatic Tests — Test 11f: Salt Spray Corrosion,” is a standard specifically tailored for salt‑spray testing of connectors used in electronic equipment. ASTM B117: “Standard Practice for Operating a Salt Spray (Fog) Apparatus,” an American Society for Testing and Materials standard, is frequently employed for continuous salt‑spray testing (e.g., 5% NaCl, 35°C).

II. National Standard GB/T 2423.17: “Environmental Testing for Electrical and Electronic Products—Part 2: Test Methods—Test Ka: Salt Spray,” which serves as the equivalent domestic standard for environmental testing of electrical and electronic products. GB/T 2423.18: “Environmental Testing for Electrical and Electronic Products—Part 2: Test Methods—Test Kb: Alternating Salt Spray.” GB/T 10125: “Artificial Atmosphere Corrosion Testing,” which specifies the general conditions for artificial‑atmosphere corrosion testing.

3. Industry/Enterprise Standards: EIA‑364‑26, an Electronic Industries Alliance standard, is specifically designed to evaluate the salt‑spray corrosion resistance of connectors, terminals, and platings, specifying detailed test conditions (e.g., 5% NaCl, 35°C, continuous spray) and acceptance criteria. GJB 150.11A, “Military Equipment Laboratory Environmental Test Methods—Part 11: Salt Spray Test,” applies to connectors used in military equipment and high‑reliability electronic systems. Enterprise/Customer Standards: Certain industries (such as automotive and new energy) or specific customers may establish customized test requirements based on actual service environments (e.g., coastal areas or industrial pollution), such as extending test durations to 96 hours, 240 hours, or even 1,000 hours.

4. Test Conditions and Acceptance Criteria Test Conditions: Typically include salt solution concentration (e.g., 5% NaCl), pH value (e.g., 6.5–7.2), test chamber temperature (e.g., 35°C ± 2°C), salt spray deposition rate (e.g., 1–2 mL/80 cm²·h), and test duration (e.g., 24 h, 48 h, 96 h, etc.). Acceptance Criteria: Primarily based on a comprehensive assessment of appearance (presence of red rust, green rust, and the proportion of corroded surface area) and electrical performance (changes in contact resistance, insulation resistance, dielectric strength, etc.).

Copyright©2024 Guizhou Gui'an New District Dongjiang Technology Co., Ltd.